Schrittmotorklemme EL7031 Konfiguration

[Auto_Well]

Zuviel Werbung?
-> Hier kostenlos registrieren

[FONT=&quot]Hallo


Could you help me pleaaaaaaaaaaase !!! how can I the EL 7031 EtherCAT Terminal configure ?? How Could I the I/O of My PLC Control assign ??
please give me both solutions for NC/Configuration and without NC /configuration [/FONT](Only PLC==Stepper Motor )[FONT=&quot]
[/FONT][FONT=&quot]I would be grateful if you could give me an example .

PS: 1- I´m a beginner with Twincat
2- I´m working with Twincat2.
thanks

[/FONT]

 

[Peteka]

First of all, do you have the required Hard-and Software?

What PLC are you using?
Does your PLC have the option to configure a NC-Task?

 

[Guga]

Zuviel Werbung?
-> Hier kostenlos registrieren

That's not going to work this way.
1: Scan the HW
2: Read the manuel -> for the PLC controlled mode you need to change the ProcessParameter Setting of the EL7031. Look within the manual.
3: Anyway, you need to parametrize the EL7031 with some motor parameters/settings. The items are described in the manual as well.
So for any further help we need the motor data.

The rest: Linking the IO to the PLC respectively using the PLC with IO is basic stuff.
When it comes to the NC I will be glad to post some words for the settings at the time being.

Guga

 

[Auto_Well]

thank youuuuu very much!!!!!!
my engine is working thanksssss :wink:

 

[Houligan15]

Hello,

who can help me? I need to connect a StepMotor with Beckhoff EL7031 and PLC from Schneider.
How can I write the parameters/ read the parameters?
@Guga : 1.what manual do you mean?
2. how can i set the items via Schneider PLC?

Thanks.